Post Filter - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
250 | Radio Frequency Distribution System
2 View the mapping list by entering: can check_mapping.
Step example:
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
3 On the mapping list, locate the removed unit indicated as Units are not present.
4 Delete the old CAN Bus unit from the CAN Bus unit mapping list by entering: can remove_mapping <X>.
<X> identifies the old unit name and is digit between 0 and 3.
Step example: can remove_mapping dpm 2.
5 Add the new CAN Bus unit to the CAN Bus unit mapping list by entering: add_mapping dpm<X><track
ID>.
<track ID> is a Track ID of the new unit.
<X> identifies the new unit name and is a digit between 0 and 3.
Step example: can add_mapping dpm 2 JTH0500102
6 View the updated mapping list by entering: can check_mapping.
7 On the mapping list, check that there are no units labeled as Track ID not mapped or Units are not
present.
Hybrid Combiner in MTS 4
For details about the Hybrid Combiner (HC), see

Post Filter

The Post Filter supports non-duplexed configurations. The Post Filter incorporates a DPM. A Post Filter is only
available for the MTS 4 because the MTS 2 does not support non-duplexed configurations. The bandwidth is 5 MHz
on 400 MHz, 6 MHz on 260 MHz, and 19 MHz on 800 MHz.
Send Feedback | September 2014 | 6802800U74-AD
Note: The new unit Track ID is present on the replaced unit label and indicated as Track ID not
mapped.
Equipment Type: ABZ89FC5827 / 109AB-5827
Hybrid Combiner on page 241.
Exhibit D2