Siemens RUGGEDCOM RX5000 Installation Manual page 9

RUGGEDCOM RX5000
Installation Guide
Figure 1: Modules
1. Control Module 2. Power Module
6. Management Ethernet Port
Module Indicator LEDs
When the RX5000 is configured for rack front mounting, these ports, controls and LEDs are located on the front
panel.
Figure 2: Front Panel
1. Power Module Indicator LEDs
Off (LT/ACO) Button
Power Module Indicator LEDs
Ports, Controls and Indicator LEDs
1
4
5
6
7
8
3. Line Module (Typical)
7. Utility USB Port
1
2. Alarm Indicator LEDs
6. RS232 Serial Console Port (DB9)
These LEDs indicate the status of the power modules.
• I = The power supply is receiving power
• O = The power supply is supplying power
2
10
9
4. Alarm Indicator LED
8. RS232 Serial Console Port (DB9)
2
3 4 5 6
3. Utility USB Port 4. Management Ethernet Port
3
4
5. Lamp Test/Alarm Cut-Off (LT/ACO) Button
9. Compact Flash Card Port
1
5. Lamp Test/Alarm Cut-
Chapter 1
Introduction
10. Power
3