Panasonic KX-T336 System Reference Manual page 1006

3. Other Conditions
The following tabular listings of items by trunk group type shows the items that
cannot be assigned ("—" is displayed) when Incoming/Outgoing mode of the trunk
group is set to "Both-Way (default)."
Trunk Group(1/2)
Type
Incoming/Outgoing
Incoming Mode(Day)
Incoming Mode(Night)
Intercept Routing(Day)
Intercept Routing(Night)
Trunk Group(2/2)
Destination (DIL 1:N Only)
Type and Number
DID Digit Modification Table
PBX Access Code (No Restriction)
PBX Access Code (Restriction)
CO-TIE Restriction
TIE-CO Restriction
TIE Forced Account Code Mode
TIE Incoming Delete Digit
TIE Incoming Insert Dial
* From software version 9.XX and above, Incoming/Outgoing mode of the trunk
group with DID can be assigned to "Both-Way," "Incoming Only," or "Outgoing
Only." However, please select "Incoming Only" if DID lines are available with
only receiving incoming calls in your area.
[Note]
When "Incoming Only" is selected in the trunk group with DID, the following items
are assignable but they do not work at all in Incoming Only mode.
• Disconnect Time
• Hook Switch Flash Time
(for areas other than U.S.A. and Canada)
In some areas, DID lines can be used for both receiving incoming calls and making
outside calls. Both-way DID card (KX-T96182D) and DID card with MFC (KX-
T96182CE) are provided for this usage.
Detailed information on KX-T96182D and KX-T96182CE are described in Refer-
ence Guide for KX-T96182D and KX-T96182CE respectively.
DDD
FEX
WATS
ATT (1/2) or
DIL 1:1
FLEXIBLE
blank
blank
blank
—
—
—
Yes
—
—
—
—
• Pause Time
• Max. Dial No. after EFA Signal
9-E-7
(70695)
PVL PBX
Both-Way
ATT (1/2) or
—
DIL 1:1
—
FLEXIBLE
blank blank
blank blank
— blank
— —
— blank
— blank
Yes Yes
— —
— —
— —
— —
DID TIE
—
—
— —
—
blank
—
blank
— blank
1 —
— —
— —
Yes —
— Yes
— No
— 0
— blank