Automatic Answering - Panasonic KX-T336 System Reference Manual

5.00 Automatic Answering

Selection
This feature automatically connects a PITS
telephone to a pre-assigned line when an
extension user lifts the handset or press the SP-
PHONE to answer incoming calls.
There are two options by which an extension user
may select a desired line.
• Ringing Line Preference-Answering (Default)
• Prime Line Preference-Answering
Operation
1. Set the MEMORY switch at
the rear of PITS to
"PROGRAM."
SET• • PROGRAM
MEMORY
2. Dial "01."
3. To change the preset
feature, dial the program
number corresponding to the
desired feature.
• To set No Line Preference,
dial "1."
• To set Ringing Line
Preference, dial "2."
If "No Line Preference-Answering" is selected, no
line is connected to a PITS telephone by lifting the
handset or pressing the SP-PHONE button.
For further information about this feature, refer to
Section 4-D-1.00 "Line Selection-Answering."
The table shows the operation for each
programming. (The explanation of the message
display applies only to a PITS provided with the
display.)
Result
• The following message
appears on the display.
PITS-PGM No.?
• The MEMORY button indicator
lights in red.
• Preset data appears on the
display.
<example>
When "No Line Preference" is
preset:
Pref. In : No
• The following message
appears on the display:
Pref. In : No.
• The following message
appears on the display:
Pref. In : Ring
12-C-18
Comment/Note
• This display is called "Initial
display for PITS-station
programming mode."
• If the following message
appears on the display, the
programming data of your PITS
has already been accessed by
another administration device.
Already Accessed
• From now on, in any status,
pressing the END button
restores this status.
• If nothing is entered within one
minute after dialing "01," the
"Initial display for PITS station
programming mode" is shown
on the display again.
• To change the assignment,
simply dial the appropriate
number again.
Continued