Table of Contents
Advertisement
Installation Instructions
Starting Up the SmartKey Code Keypad with Reader
(or changing user codes)
The user code for the NZ 300 LSN and "integrated" SmartKey is described in de-
!
tail in the NzPara online help under "User Codes" (different default setting).
Define user code or change user code
(when the system is disarmed) as follows:
1. Simultaneously press the "C" and "
The reader's buzzer will sound for 1 second and the red and green LEDs will flash.
2. Press and hold the key button and hold the SmartKey up to the reader for > 1 second. This
will assign the SmartKey to the corresponding user number (ID). Users without a key must
enter their user number (ID).
The buzzer will sound for 1 second and the LEDs will be deactivated.
3. When starting up for the first time, enter "000000" and confirm your input with the "
- or,
If you want to change the user code, enter the "old user code" and confirm your input with the
"
" key.
The reader's buzzer will sound for 1 second and the green LED will light up.
4. Enter the new user code and confirm your input with the "
The reader's buzzer will sound for 1 second, the green LED will light up and the red LED
will flash.
5. Enter the new user code once again and confirm your input with the "
The reader's buzzer will sound for 3 seconds, and the green and red LEDs will light up for
3 seconds and then go out.
The new user code is now valid.
Define your user code during the first start-up. You can chan-
ge your user code at a later date. Both operational proce-
dures are identical.
Use this key to verify entries.
Use this key to abort an operation.
" keys for 3 seconds.
22
" key.
" key.
" key
Advertisement
Table of Contents
