Table of Contents
Advertisement
1.
Key with security card:
Reading in keys during programming
Programming the SE 220 LSNi system and reading in the key identification number is car-
ried out with the appropriate programming program (e.g. WinPara or NzPara). This is when
the key's 8-digit identification number is entered into the system. In the programming pro-
gram, select for the keys to be read in during programming (select the parameter "inte-
grated" for SE 220 when using NzPara). The maximum number of keys depends on the
control panel in use.
Reading in occurs in two stages. First, the security card is read in. Reading in the security
card at the reader replaces the manufacturer's general works code with the individual cus-
tomer code. This is followed by programming and the 8-digit identification numbers of the
keys are entered.
Operation sequence:
1.
The plugs with the LSN lines (3.4 and 7.8) must be removed from the control unit.
!
The control panel will display an LSN line malfunction message.
2. Connect the jumper on the control unit's circuit board to bridge B2.
4. Connect the jumper back to B1.
The yellow LED on the control unit and the red LED on the reader go out.
5. Reconnect the plugs with the LSN lines to the control unit and reset the LSN line mal-
function message on the control panel.
6. In the programming program, select for the keys to be read in during program-
ming (select the parameter
keys' 8-digit identification number into the programming program and program the control
panel.
This completes programming the keys.
Installation Instructions
3. Hold the front or the reverse side of the security card parallel
to the reader at a maximum distance of 2 cm until the red LED
lights up.
This completes reading in the security card.
"integrated" for SE 220 when using NzPara). Enter the
17
Advertisement
Table of Contents
