Completing Basic Setup; Completing The System Configuration - HP ML110 G1 User Manual

Configure the System Information. Click Next to continue.
7.
8. Verify that your information is correct when the configuration review
screen is displayed as shown in
Figure 2
Click Finish to exit Rapid Startup. If a reboot is required, Rapid
9.
Startup displays a message that a reboot is occurring and the
configuration information will be set.
The browser returns to the status page. The refresh may take several
minutes if the device was restarted.
NOTE:
Welcome page becomes the default page.

Completing basic setup

This completes the basic configuration of the HP ProLiant Storage Server,
however, some computing environments may require additional settings
and configuration as noted below.

Completing the system configuration

Most of these tasks can be completed using the WebUI. All procedures
for the configuration tasks may be found in the HP ProLiant Storage
Server Administration Guide.
• Place the storage server into an Active Directory or Windows NT®
4.0 domain for ease of manageability (highly recommended).
• Enable protocols such as NFS sharing, NCP, and/or AppleTalk.
• Create shares corresponding to the protocols mentioned in the
previous steps.
Rapid Startup configuration review screen
After the Rapid Startup Wizard has been completed the
Figure 2.
Storage Server user guide 21