Method 2: Direct Attach; Procedure - HP ML110 G1 User Manual

3. Open Internet Explorer on the PC. Enter https://, the serial number
of the storage server followed by a hyphen (-), and then:3202. Press
Enter.
Example: https://D4059ABC3433-:3202
NOTE:
name was previously set.
4. Login to the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP ProLiant Storage Server,
as shown in
NOTE:
the password is hpinvent. The WebUI uses the same login as the
local administrator's account or an account with administrative
privileges.
5. Go to
the setup procedures.

Method 2: Direct attach

You can access the WebUI using a monitor, mouse, and keyboard
directly attached to the storage server.

Procedure

To initialize the storage server:
1. Connect the Ethernet cable to the network port of the storage server
and the corresponding network segment.
2. Connect the monitor, mouse, and keyboard directly to the rear panel
connectors of the storage server.
3. Power on the storage server.
4. Login into the device using the WebUI user name and password.
NOTE:
the password is hpinvent. The WebUI uses the same login as the
local administrator's account or an account with administrative
privileges.
5. Open Internet Explorer to launch the WebUI configuration application
(Rapid Startup) on the target storage server, as shown in
the WebUI does not launch connect to the LocalHost and login to the
WebUI.
6. Go to
Substitute the server name for the serial number if a server
Figure 1.
The default login for the WebUI is administrator and
"Rapid Startup Wizard
The default login for the WebUI is administrator and
"Rapid Startup Wizard
configuration" on page 20 to complete
configuration" on page 20.
Storage Server user guide
Figure 1. If
19