Miter Gauge Installation; To Store The Table Saw Accessories - Hitachi C 10RJ Safety Instructions And Instruction Manual

G
D
F
B
2
Fig. 11c
MITER GAUGE INSTALLATION (FIG. 12a-12b)
The miter gauge (A) can be installed on each miter gauge groove (B) on either side of blade.
• Remove the miter gauge (A) from storage area (C) located on inside of the right side of saw).
• Slide the guide rail (D) of the miter gauge (A) into one of the guide grooves (B) of the saw table intended
for this purpose.
1
C C
Fig. 12a
TO STORE THE TABLE SAW ACCESSORIES (Fig. 13a-13c)
• The table saw has two convenient storage areas (one on either side of the saw) specifically designed for
the saw's accessories: rip fence assembly (A), blade guard assembly (B), push stick (C), blade wrenches (D),
plug cable (E), anti-kickback pawls (F) and miter gauge (G).
• When not in use, store accessories securely.
C
Fig. 13a
C
H
H B
CC
0 1
8 9
A
A A
A
A A
F C
B A
Fig. 13b
Position screw BB: Begin with 8 in. to 35 in. end.
(Rip fence located on the right of the blade)
Position screw CC: Begin with 0 to 22 in. end. (Rip
fence located on the left of the blade)
AA
2 22 23 24
10 30 31 32
BB
A D
Fig. 12b
A
D E
C
G
English
25 26 27
33 34 35
B
B
G
B F
Fig. 13c
25