Battery Removal/Installation - Hitachi WH 9DMR Handling Instructions Manual

English
Charger
Model
Charging voltage
2.0 Ah
2.6 Ah
Charging time
3.0 Ah
3.3 Ah
Weight
All charge times are approximate. Actual charge time may vary.
"x" Indicates that the battery pack is not compatible with that specific charger.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle 3 tightly and push the battery latch
2 to remove the battery 1 (See Fig. 1 ).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery 1 while observing its polarities
(See Fig. 1).
CHARGING
〈UC14YFA, UC24YFA, UC18YRL, UC18YFL〉
Before using the impact driver or impact wrench, charge
the battery as follows.
1. Connect the charger's power cord to a receptacle
When the power cord is connected, the charger's
pilot lamp will blink in red (At 1-second intervals).
Table 1
Blinks
Before
charging (RED)
While Lights
charging (RED)
Blinks
Charging
(RED)
complete
Charging Flikers
impossible (RED)
Overheat Lights
standby (GREEN)
NOTE: When standby for cooling battery, UC18YRL cools the overheated battery by cooling fan.
43
UC14YFA UC24YFA
7.2 – 14.4 V 7.2 – 24 V
50 min. 50 min.
65 min. 65 min.
70 min. 70 min.
75 min. 75 min.
0.6 kg 0.6 kg
Indications of the lamps
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for
0.1 seconds. (off for 0.1 seconds)
Lights continuously
UC18YGH UC18YG
7.2 – 18 V 7.2 – 18 V
50 min. 50 min.
65 min. x
70 min. x
75 min. x
0.35 kg 0.3 kg
2. Insert the battery into the charger
Insert the battery firmly, until it contacts the bottom
of the charger compartment.
CAUTION
If the battery is inserted in the reverse direction,
not only recharging will become impossible, but
it may also cause problems in the charger such as
deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red (At 1-second intervals)
(See Table 1).
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the
charger or the rechargeable battery.
UC18YRL / UC18YFL
7.2 – 18 V
30 min.
40 min.
45 min.
50 min.
0.7 kg
Malfunction in the battery
or the charger.
Battery overheated.
Unable to charge
(Charging will commence
when battery cools).