Panasonic KX-NS1000 Pc Programming Manual page 64

3.1 Home Screen
These 15 icons represent Slave unit PBXs under the control of the Master unit PBX. Units that have been
registered display a unit name and are colored in. Remaining available unit positions are shown as grayed
out. You can right-click a registered PBX and select Maintenance, Setup, or Direct Login for that PBX.
Selecting Direct Login will display the Login screen for that PBX. For details about the login procedure,
see 2.1.3 Logging in to Web Maintenance Console.
If the PBX is operating as the Master Backup unit or is in Isolated mode, but the Master unit has been
restored to normal operation, you can right-click the PBX's icon and select Normal Mode to restore the
PBX to normal operation. (It will reconnect to the Master unit PBX as a Slave unit.)
The desired method for recovering from Isolated mode to Normal mode can be specified. For details, refer
to 8.4.2 One-look Networking Survivability in the Installation Manual.
Note
•
For the following items related to the Unified Messaging (UM) programming of a Slave unit, you
must select Direct Login to log in to the PBX that the UM Group in which programming will be
performed belongs to:
–
4.1.4 Status—Equipment Status—UM Port status
–
4.1.5 Status—Equipment Status—USB
–
5.3 System Control—FAX Card
–
6.1.1 Tool—System Data Backup—Backup to USB
–
6.8 Tool—UM Data Backup
–
6.9 Tool—UM Data Restore
–
6.10 Tool—UM Backup History
–
7.3.4 Utility—Log—UM System Log
–
7.4.8 Utility—Monitor/Trace—UM System Trace (Internal)
–
7.4.6 Utility—Monitor/Trace—Fax - Protocol Trace
–
7.4.7 Utility—Monitor/Trace—Fax - Task sequence Trace
–
7.5.3 Utility—Report—UM View Reports
–
7.8 Utility—Command
–
7.9 Utility—UM – System Prompts Customization
–
UM Configuration settings
(For details for UM Configuration settings, see "Section 20 UM Configuration—[1] Mailbox
Settings" to "Section 26 UM Configuration—[7] System Security".)
PBX Status Icons
If the PBX is in service (INS) and operating normally, the unit will be displayed as shown above. Icons are
displayed on PBX units when they are not in service and operating normally. The following icons are displayed
on PBX units according to their status:
Icon
Connection Error (Status Unknown)
The site where you are logged in cannot communicate with the sites displaying
this icon and cannot determine their status.
Maintenance Mode
This PBX is installed but it is out of service (OUS) and maintenance is being
performed on it. PBXs with this icon are visible on the home screen, but they are
currently not connected to other PBXs in the One-look network.
Pre-install Mode
This PBX is installed but it is out of service (OUS) and has not yet been put in
service (INS). The free trial period for activation key trials has not yet begun.
64 PC Programming Manual
Description
Document Version 2016-03