Reset To Factory Defaults - Technicolor TG789vac v2 Setup And User Manual

8.4 Reset to factory defaults

Resetting your TG789vac v2
If at some point you can no longer connect to the TG789vac v2 or you want to make a fresh install, it may be useful to
perform a reset to factory defaults.
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a
reconfiguration of your TG789vac v2 will be needed.
Also your wireless clients will have to be re-associated, as described in
Methods
You can choose between:
• Resetting the TG789vac v2 via the web interface
• Reset the TG789vac v2 via the Reset button
Resetting the TG789vac v2 via the web interface
Proceed as follows:
1 Browse to the TG789vac v2 web
For more information, see
2 Click Gateway. The Gateway page appears.
3 Click Reset.
4 The TG789vac v2 restores the factory default configuration and restarts.
Reset the TG789vac v2 via the Reset button
Proceed as follows:
1 Make sure the TG789vac v2 is turned on.
2 Push the Reset button for at least 7 seconds and then release it.
3 The TG789vac v2 restarts.
Your system administrator may have disabled the physical reset button of the TG789vac v2. In this case, a hardware
reset to defaults is not possible.
Restore your settings
If you previously backed up your configuration, you can now restore this configuration on your TG789vac v2.
For more information, see
DMS3-CTC-25-191 v2.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
interface.
"4.1.1 Accessing the TG789vac v2 web interface from your local network" on page
"4.4 Backing up/restoring your configuration" on page
"3 Wireless networking" on page
Reset
61.
8 Support
23.
38.
83