Technicolor TG588v v2 Configuration Manual

Hide thumbs Also See for TG588v v2:

See also: Setup and User's Manual

Technicolor TG588v v2 – Manual Configuration

Note: We recommend changes made to this router are performed by a computer using a Windows

operating system and connected via an Ethernet cable. Using a computer with a MAC operating

system or wireless device may cause issues and settings may no save correctly. If the router has been

previously configured using one of these devices it is best to factory reset the router before

continuing with a computer using Windows.

The following guide shows how to manually configure a Technicolor TG588v v2 router to work with

an FTTC or ADSL.

It is recommended the router is first factory reset before following this guide. This can be achieved

by holding a paperclip in the reset hole for 15 seconds, located on the rear of the unit.

Using a web browser navigate to 192.168.1.1 and click sign in.

Table of Contents

Need help?

Do you have a question about the TG588v v2 and is the answer not in the manual?

Page 1 Windows. The following guide shows how to manually configure a Technicolor TG588v v2 router to work with an FTTC or ADSL.
Page 2 The default username is admin and default password is admin. Once this has been entered you will get the following prompt. It is recommended to use serial number of the router as the new password.
Page 3 Click Setup your gateway. Configuring for FTTC By default the option for VDSL (FTTC) is selected and Enabled is off. Make sure Enabled is toggled...
Page 4 Enter the username and password provided by your ISP. If configuring for VDSL/FTTC make sure make sure MTU is set to 1492 and VLAN is enables with the ID of 101. This should be the default setting. Once complete click Save to finish the process. You may need to wait a few minutes for the router to connect.
Page 5 The default settings for MTU (1500), ATM VP (0), ATM VC (38), and Encapsulation Type (VCMUX) can be left as they are. Click on Save to complete the process. The TG588v v2 has now been configured. Please allow a few minutes for the router to try and connect with the new settings.