Mitsubishi Electric GOT2000 Series User Manual page 103

■2. Part names and settings OF GT23
No.
1) Display section
2) Touch panel
3) POWER LED
4) Unit installation fitting
5) S.MODE switch
6) SD card access LED
7) SD card interface (inside the cover)
8) SD card cover
9) USB interface (Host)
10) USB interface (Device)
11) Cable clamp mounting hole
Terminating resistor setting switch (inside
12)
the cover)
13) Battery (inside the cover)
14) Vertical installation mark
15) Power terminal
16) Ethernet interface
17) Ethernet communication status LED
18) RS-232 interface
19) RS-422/485 interface
Name
Displays the utility and the user-created screen.
For operating the touch switches in the utility and the user-created screen
Lit in blue
Lit in orange
Blinks in orange and blue: Backlight failure
Not lit
Mounting fixtures for fixing the GOT to the control panel
Used for OS installation at the GOT startup
ON: SD card installed
Blink: SD card accessed
OFF: SD card not installed or SD card installed but removal possible
For installing an SD card
Has the function to switch the access to the SD card between enabled and disabled states.
When the cover is opened: Access prohibited
When the cover is closed: Access allowed
For connecting a USB mouse and a USB keyboard, transferring data, and storing data
(Connector shape; TYPE-A)
For connecting a personal computer (Connector shape: Mini-B)
Cable clamp mounting hole as a precaution against a disconnection of the USB cable
(Recommended product: RSG-130-V0 of KITAGAWA INDUSTRIES CO.,LTD.)
Switches the terminating resistor for the RS-422/485 communication port between used and
unused states (initial setting (unused))
Space for housing the battery
When using the GOT with the vertical display, install the GOT so that the arrow points upward.
Power input terminal, LG terminal, FG terminal
For communicating with a controller or connecting a personal computer (Connector shape:
RJ-45 (modular jack))
SD/RD LED ON: Data sent or received
SD/RD LED OFF: Data not sent or received
SPEED LED ON: Communicating at 100 Mbps
SPEED LED OFF: Communicating at 10 Mbps or disconnected
For communication with a controller (Connector shape: D-sub 9-pin (male))
For communication with a controller (Connector shape: D-sub 9-pin (female))
Description
: Power is properly supplied.
: Screen saving
: Power is not supplied.
4 - 11
4.3 GT23
4