Power On Password - Mitsubishi Electric APRICOT FT//EX User Manual

NOTE: After setting a password, you have to set jumper JP6 to
pins 1-2 to enable the security feature.
If You Forget Your Password
If you forget your password, you have to reset the configuration values stored
in CMOS to their default values. When this happens, call your dealer for
assistance.
5.5.4

Power On Password

The Power On Password secures your system against unauthorized users. To set
this password, follow the same procedure as in setting a Setup Password in
section 5.5.3.
Operation Mode
This item gives you an option to choose when the password prompt appears.
You can select either Before Booting or After Booting.
When you choose Before Booting, the password prompt appears after the power
on self-tests (POST). The system boots when you type in the correct password.
If you key in a wrong password, an "X" appears. If you type a wrong password
three times, the system hangs. When this happens, you have to reset the system
or power it off and then on again.
When you choose After Booting, the system executes POST, boots and displays
the DOS prompt. Type in your password. The password prompt does not appear
here but the keyboard is locked until you type in the correct password.
Configuring the System 5-1