Table of Contents
Advertisement
2.6.3
Correcting Error Conditions
As a general rule, if an error message says "Press F1 to continue," it is caused
by a configuration problem, which can be easily corrected. An equipment
malfunction is more likely to cause a so-called fatal error, i.e., an error that
causes complete system failure.
Here are some corrective actions for error messages:
1.
Run Setup. You must know the correct configuration values for your
system before you enter Setup, which is why you should write them
down when the system is correctly configured. An incorrect Setup
configuration is a major cause of power-on error messages, especially
for a new system.
2.
Remove the system unit cover, following the directions in Chapter 1.
Check that the jumpers on the system board and any expansion boards
are set correctly.
3.
If you cannot access a new disk, it may be because your disk is not
physically formatted. Physically format the disk first using the FDISK
and FORMAT commands.
4.
Check that all connectors and boards are securely plugged in. Review
the sections in Chapter 1 for assistance.
If you go through the corrective steps above and still receive an error message,
the cause may be an equipment malfunction.
If you are sure that your configuration values are correct and your battery is in
good condition, the problem may lie in a damaged or defective chip.
In both cases, contact an authorized service centre for assistance.
System Board 2-15
Advertisement
Table of Contents
