Canon X-07 User Manual page 59

1.7.6
How to verify a program
Once a program is saved, it should be checked to make sure that it was saved
correctly. This is because cassette recorders and cassette tapes are not made to
record programs, and distortions can be added when they are used to perform
such functions.
The CLOAD? command is used to verify a program.
First, rewind the tape to a position a little before the beginning of the pro­
gram. Next, set the cassette recorder to the playback mode. If the REMOTE
jack is connected, the cassette recorder will remain in the stop mode. Next,
type,
CLO AD?
The cassette tape begins to move, and soon, the following is displayed:
Found: FILE
The above display means that the program with the file name "FILE" has
been saved correctly.
If a program has been saved correctly, no message is displayed, the cassette
recorder is stopped (if in the REMOTE mode), and the cursor is displayed. If
the saved program does not match the program in the text area, "Bad" is
displayed and the cassette recorder is stopped. In such a case, you must resave
the program�
To execute the CLOAD? command when using a cassette recorder without a
REMOTE jack, type,
CLOAD?
and then, put the cassette recorder into the playback mode.
so
"FILE"
'-
File name