Canon X-07 User Manual page 44

Erasing an old program
1 .5 .3
Even after a program has been saved in the RAM file, it is still retained in the
text area. In order to create a new program, the old program in the text area
must first be erased. This is accomplished with the NEW command.
NEW
Next, use the LIST command to check whether the program has been erased.
�
LIST
�
Nothing is displayed; therefore, the program has been erased. Now, you can
create another program. As the contents of the text area are retained even
when the power is turned OFF, don't forget to erase an old program. If an old
program is not erased, an unexpected trouble might arise. So, please be
careful.
1.5.4 Loading from the RAM file
The LOAD command is used to load a saved program into the text area.
LOAD "PROG1" RETURN
Now, contents of
sure, please execute the LIST command.
A p rogram saved in the RAM file can also be executed without first loading it
i nto the text area by using the RUN command.
PROGl
should have been loaded in the text area. To make
35