Hitachi IJ RX2 Technical Manual page 72

● Target sensor filter
ESC2
● Target sensor filter setting value
ESC2
● Ink drop charge rule
ESC2
Charge rule (31H:Standard, 32H:Mixed single scan and interlaced 33H:Dot mixed)
● Two or more print specification items can be consecutively transmitted in a single chain.
[Existing machine message] Existing machine message can also be used.
●Character height
ESC
● Character width
ESC
● Character orientation
ESC
●Repeat intervals
ESC
●Repeat count
ESC
● Print start delay
ESC
● Print start delay (reverse)
ESC
●Target sensor timer
ESC
●Target sensor filter
ESC
ESC
●High-speed printing
ESC
●Product speed matching
ESC
Product speed matching (0:Time-based, 1:Encoder based)
●Pulse rate division Factor
ESC
●Ink drop use percentage
ESC
5-16 ●Transmission Sequences
Classification
Header 25H
40H
Division (1:time setup, 2:until end of print)
Classification
Header 25H
41H
Classification
Header 25H
42H
Header 30H 10s place
Character height (00 to 99)
Header 31H 100s place
Character width (000 to 199)
Header 32H Units place
orientation
Character (0 to 3)
Header 34H 1000s place
Repeat intervals
Header 35H 1000s place
Repeat count (0000 to 9999)
Header 33H 1000s place
Print start delay (0000 to 9999)
Header 36H 1000s place
Print start delay (reverse) (0000 to 9999)
Header 37H 100s place
Target sensor timer (000 to 999)
Header 38H 1000s place
Target sensor filter (0000 to 9999)
Header 39H Division
Division (1:time setup, 2:until end of print)
Header 3AH Mode
Mode (0:HM, 1:NM, 2:QM)
Character
Header 3BH
orientation
Header 3CH 100s place
Pulse rate division Factor (001 to 999)
Header 3DH 10s place
Ink drop use percentage
Division
1000s place 100s place
Value (0000 to 9999)
Charge rule
Units place
10s place Units place
100s place 10s place Units place
(0000 to 9999)
100s place 10s place Units place
100s place 10s place Units place
100s place 10s place Units place
10s place Units place
100s place 10s place Units place
10s place Units place
Units place
(01 to16)
10s place Units place