Replacing The Ink Filter - Hitachi IJ RX2 Technical Manual

6.7 Replacing the ink filter

Perform it in a state in which the ink has been drained. The ink is not wasted if performed
simultaneously with the ink replacement.
Display the Circulation control screen and press the Ink filter replacement →
1
Start/Continue .
Ink replacement
2
2
Follow the operation guidance on the screen and drain the ink from the ink
filter and ink circulation system.
● Press Abort to cancel ink draining.
● When Abort is selected, go back to setup
If ink is accidentally spilt, wipe it up promptly with wiping paper or equivalent.
In addition, do not close the maintenance cover until you are sure that the wiped area
is completely dried.
( Change the direction of the ink filter so that tubes become the bottom,
a)
disconnect the recovery block from the main ink tank and put it in a beaker.
6-17 ●Replacing the ink filter
Circulation control
Eject ink
Cleaning stop
(Goes to Standby)
Recovery-line
Nozzle backwash
cleaning
Ink filter
Ink replacement
replacement
Process prior to Process after
long-term shutdown long-term shutdown
Select option; press [Start/Cont.]
CAUTION
Recovery tube
[Stop ]
Com=0
No-cleaning stop
Ink circulation
Makeup refill
Proc. status:
above and continue.
1
Ink filter
Ink filter tubes
2015.07.07 12:45
HOME
Prev.Dsp. Next Dsp.
Cancel
Start/Continue
Start/Continue