Philips bClever SV1 User Manual page 35

Poor colour
Image is blurred
Picture rolls
No sound
The projector does not
react to commands from
the remote control
Philips Multimedia Projector
7.Troubleshooting
In case of YPbPr connection
– 'YPbPr' is not selected in the menu and 'Auto Source' is activated. In this case 'Auto Source' will not
recognize 'YPbPr'.
Select 'YPbPr' as projection source in the 'Set up' menu ('Auto Component Selection' sub
•
menu).
In case of RGBsog (Scart) connection
– 'RGBsog' is not selected in the menu and 'Auto Source' is activated. In this case 'Auto Source' will
not recognize 'RGBsog'.
Select 'RGBsog' as projection source in the 'Set up' menu ('Auto Component Selection' sub
•
menu).
Adjust 'Brightness', 'Contrast', 'Tint' or 'Hue' (see 'Picture adjustment' under 'Operation' - 'On
•
Screen Display Menu').
Reset all projector settings in the 'Set up' menu ('Factory reset').
•
Note
Please note that all other projector settings will be reset as well.
In case of YPbPr or RGBsog (Scart) connection
– Wrong component source selected in the menu:YPbPr i.s.o. RGBsog or vice versa.
Check what source has been connected ('YPbPr' or 'RGBsog') and select this source the 'Set
•
up' menu ('Auto Component Selection' sub menu).
– Image is not focused.
Adjust focus ring.
•
– Distance between projector and screen is not correct.
Adjust the distance between the projector and the screen. Please check the 'Projector
•
Assistant' programme on the CD-ROM
– Signal cable is not correctly connected.
Connect signal cable correctly.
•
– Signal cable is not correctly connected.
Connect signal cable correctly.
•
– Audio cable is not correctly connected.
Connect audio cable correctly.
•
– Volume is not adjusted properly.
Adjust volume.
•
– (A/V-)Mute active.
Cancel (A/V-)Mute.
•
– Distance is too great.
Reduce distance.
•
– Batteries are exhausted.
Replace batteries (see 'Inserting the batteries in the remote control').
•
– IR sensor is obstructed.
Remove obstacle.
•
35
English User guide bClever SV1
>