Moving/transporting the
projector
Inserting the batteries in
the remote control
Philips Multimedia Projector
3. Set up
Preparation
y
Press the
Standby button twice to put the projector in Power/Standby.
1
–
The Standby indicator starts blinking red.
Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
2
Standby) and disconnect the mains lead and all other cables.
Put the lens cap back in place to prevent dust, dirt or other contamination from harming or
3
damaging the front of the projector lens when moving the projector.
Note
Never place the projector on the side where the connections are located.
Moving/transporting the projector
The projector contains many glass and precision parts. If you need to transport the projector,
please follow these packing instructions to prevent accidental damage to the projector.
•
When you are hand-carrying the projector, be sure to use a carrying case like the optional
softbag.
•
When shipping the projector, use the original packaging material if possible. If you do not
have the original packaging, use equivalent materials, placing plenty of cushioning around the
projector.
•
When transporting the projector as freight or checked luggage, first put it in a carrying case,
then pack it in a firm box, using cushioning around the case.
Push and slide the lid in the direction of the arrow.
1
Install two 'AA' batteries as indicated inside the battery compartment.
2
Replace the lid and snap it into place.
3
Note
The maximum range of the remote control is approximately 15 m (± 50 feet).
13
English User guide bClever SV1
<