Mitsubishi Electric AE-200A Service Handbook page 32

[IV Product specifications and functions]
(2) Back of AE-200/AE-50
Service cover
* To remove the service cover,
you need to remove the two
fixing screws from the back and
then unhook the hooks at the
bottom.
* When attaching the service
cover, be sure to hook the hooks
before securing the cover with
the two screws.
Item
LAN1
LAN2
CN7 Pulse input
CN6 RS-422/485
CN4 RS-232C
CN5 External I/O
TB3 M-NET A, B, S
(M3.5)
Ground (M4)
CN21 M-NET power jumper
TB1 AC power supply
L/L1, N/L2
(M3.5)
Connect with other equipment over a LAN via a switching HUB.
Planned to be used with BACnet
Connect the pulse detector of an electricity meter.
Unused
Unused
Cut out the knockout hole and then connect an external I/O adapter (PAC-YG10HA).
M-NET transmission line terminal block
Connect with an outdoor unit using an M-NET transmission line.
(A, B: Non-polarized, S: Shielded)
Connect a ground wire for protection.
Connect the power jumper to supply power to M-NET (default).
If another system controller is connected to the same M-NET, disconnect the power
jumper to supply power to the M-NET from the power supply unit.
Connect an AC power supply cable.
28
Description