Canon EOS C700 Instruction Manual page 180

IP Streaming
3 Activate IP streaming on the camera.
Setup screen:
Monitoring menu:
• and the connection type icon will appear on the HOME screen and at the top left of the monitoring
180
screen. When the icons turn white, the camera will start streaming video over the selected network.
• You can press the REC button to record clips (XF-AVC only) while streaming video.
• If the main recording video configuration used does not support IP streaming, a message will appear asking
you to change the video configuration. The video configuration you select will be saved as the main
recording video configuration and will be used even after you finish IP streaming.
4 When using the [RTSP+RTP] protocol, connect the RTSP controller (IP decoder or computer) to the
camera's IP stream. If necessary, you can check the network settings while IP streaming is activated.
Setup screen:
Monitoring menu:
• Turn the SELECT dial to check all the settings. You will need the IP stream's URL and the RTSP user name
and password.
• Only the default password is displayed. Passwords set by the user will not be displayed (the information
screen will show only whether a password is set or not).
5 When you have finished streaming the desired video, turn off the IP streaming on the camera.
Setup screen:
Monitoring menu:
• The network icons will turn yellow and then disappear from the HOME screen and monitoring screen.
NOTES NOTES
• Except when using the RTSP protocol, while IP streaming is activated, the camera will continue to broadcast
video and audio data over the IP network, regardless of the status of the receiver. The streamed data is not
encoded. Be careful to set up the correct IP address and test in advance that the receiving decoder can
indeed receive the signals.
• Depending on the network used and the connection conditions, you may experience lost or delayed IP
packets.
• IP streaming is not available in the following cases.
- When the main recording frame rate is set to 23.98P.
- When slow & fast motion recording is activated.
[NETWORK] > [IP Streaming] > [ACTIVATE] (set it to [On])
[System Setup] (B) > [Network Settings] > [IP Streaming] > [Activate] > [On]
[NETWORK] > [IP Streaming]
[System Setup] (B) > [Network Settings] > [IP Streaming] > [Display Info]
[NETWORK] > [IP Streaming] > [ACTIVATE] (set it to [Off])
[System Setup] (B) > [Network Settings] > [IP Streaming] > [Activate] > [Off]