Canon EOS C700 Instruction Manual page 170

Browser Remote: Controlling the Camera from a Network Device
1 Live view screen
Shows the camera's live view image. When the live view image is not turned on, the camera ID and lens
information will appear here.
2 Status indicators
170
STBY, etc. :
`
STBY , REC
4
:
DC IN 00.0V,
BATT 00.0V:
3 [LIVE VIEW] button
Touch the button to display the camera's live view image on the Browser Remote screen.
D
4 [ Touch Focus] button
Touch the button to unlock (enable) the touch focus mode.
5 Clip marks buttons
When recording, you can tag important clips by adding clip marks (A 117).
To add a clip mark: After recording a clip, touch [
a % mark to the clip. When the [OK Mark] or [CHECK Mark] message appears, touch
NOTES
• Depending on the Wi-Fi connection's strength, there may be delay of 0.5 seconds or more between the
frame shown when you touch the button and the frame to which the camera adds the shot mark.
6 Browser Remote screen selection ([Full] user only)
Touch [v] to open the main remote recording screen, [
open the basic screen for devices with a small screen (A 175).
7 Language selection
Changes the language used for controls in the [
most of the application's controls emulate physical buttons on the camera and appear in English only,
regardless of the language selected.
8 Key lock button
Touch the icon to lock the Browser Remote screens in order to prevent settings from being changed
inadvertently.
9 [REC] button
Touch the button to start recording. While recording, the center of the button turns red.
Touch the button again to stop recording.
10 Recording media selection and approximate remaining recording time
The currently selected CFast card is indicated with a Ð mark next to the icon.
Remaining recording times are approximate and calculated based on the current video configuration used.
11 [SLOT SELECT] button
Touch the button to select the other CFast card when both CFast card slots contain a CFast card.
: Wi-Fi connection indicator. While Browser Remote is correctly connected to the camera, the
dots will keep turning on and off in a loop.
Recording operation (same as on the camera, A 57).
`
: Output recording command (A 189).
Appears during double slot recording (A 52).
Camera's power source (DC IN and battery) (A 26). The power source currently in use is
Ð
indicated with a mark.
Mark] to add an $ mark to the clip, or [
] to open the metadata screen (A 176) or [ ] to
] (metadata input) screen and for error messages. Still,
Mark] to add
.