Neutralising Agent; Replenishing Neutralising Agent - Miele PG8582 CD Operating Instructions Manual

Adding and dispensing chemical agents
Replenishing

neutralising agent

56
Neutralising agent
For certain programmes, neutralising agent is dispensed in the interim
rinse phase after washing, to help prevent discolouration and
corrosion spots on the instruments (especially around jointed areas).
Neutralising agent (pH setting: acidic) neutralises any residues of
alkaline cleaning agents on the surface of the load.
Neutralising agent is dispensed automatically in the
phase after the main wash (see Programme charts). The reservoir
must be filled and the dispensing system vented for this to occur.
Open the drawer in the side unit.

Remove the neutralising agent container (red marking) and place it

on the open cabinet door or on a surface which is robust and easy
to clean.
Unscrew and remove the siphon. Place the siphon on the open

cabinet door.
Replace the empty container with a full one.

Push the siphon into the opening of the container and screw it back

on tightly. Observe the colour coding.
Wipe up any spilled chemical agent thoroughly.

Place the container back in the drawer in the side cabinet.

Close the drawer. Ensure that the dispensing tubes and cables are

not kinked or trapped.
The dispensing system must then be vented (see "Settings /DOS

venting").
Interim rinse