Further settings
88
Programme settings
You can use this menu to customise the current programme to suit
technical requirements and the wash load or to reset all programmes
to the factory default settings.
Additional specialist knowledge is required to alter programme
settings and this should therefore be undertaken only by experienced
users or by Miele Service.
More information can be found in "Programme settings".
Air cooling
During the drying phase, the hot exhaust air from the wash cabinet is
released into the room via the steam condenser. Depending on the
size of the room, this can heat up the room to a greater or lesser
degree.
To reduce this effect, the heated air can be cooled down during the
drying phase using a fine spray in the steam condenser.
Cooling in the steam condenser will increase water consumption.
Open the menu as follows:
button
Further settings
Air cooling
Air cooling
Yes
–
Hot air is cooled using the steam condenser.
No
–
Hot air is released uncooled into the room.
Select an option using the and arrow buttons.
Press OK to save the setting.
Yes
No