Programme Settings; Adjusting Programme Settings; Programme Structure; Programme Header - Miele PG8582 CD Operating Instructions Manual

Programme settings

Programme
header
98

Adjusting programme settings

The programme settings should be adjusted to suit technical
requirements and the load.
Additional specialist knowledge is required to alter programme
settings and this should therefore be undertaken only by experienced
users or by Miele Service.
Programme and dispensing changes must be documented for
validated processes. In Germany this is a requirement of the
Medical Devices Operator ordinance (MPBetreibV).
The process must be validated again as necessary.

Programme structure

Each programme is subdivided into programme blocks which run one
after another. A programme consists of at least one and a maximum
of eleven programme blocks. Each block can occur only once in a
programme.
The so-called programme header is placed above the programme
blocks and contains general programme settings. Individual wash
block parameters are also globally activated or deactivated here.
Change volume of water
–
Each programme block is allocated a nominal water quantity. The
water quantity can be raised or lowered incrementally for all blocks
to the base value in the programme chart.
– Drain time
If the on-site waste water system is insufficient to drain the waste
water from the wash cabinet within the time allocated, the drainage
time can be lengthened by a set amount.
Parameters for measuring water pressure and spray arm pressure
can only be accessed by Miele Service.