Upgrading From Version 1.0, 1.1, 1.2 And 1.3 - Canon VK-16 Setting Manual

Upgrading from Version 1.0, 1.1, 1.2 and 1.3

When installing over an earlier version, VK-64 / VK-16 will attempt to use settings from
your previous installation. It is important to verify your settings after installation.
● If you are using VK-64/VK-16 with NAS server, you need to set
up log-on settings again after upgrading VK from v1.3 to v1.4.
Note
● The Viewer v1.4 can connect to the Storage Server v1.2 and
v1.3. However, if you connect to the Storage Server v1.2, you
cannot use the recording functions which are not supported by
v1.2 (e.g., preset tour).
● If the Storage Servers v1.2, v1.3 or v1.4 coexist, either Storage
Server can be specified as the Master Storage Server.
● The Viewer v1.4 cannot connect to the Storage Server v1.0 or
v1.1.
● The Viewer v1.0, v1.1, v1.2, or v1.3 cannot connect to the Storage
Server v1.4.
● When upgrading from any versions before 1.1.2.27, you need
to set motion detection (➝ P. 85) again. You can check your
version information from the About box (➝ P. 25) of the
Storage Server and the Viewer.
● The VB-C300 cannot be registered on the Storage Server v1.0,
v1.1 or v1.2.
Installation Procedures
1
21