Powering On The Te30; Loading The Configuration File - Huawei TE30 Quick Start Manual

Quick Start Guide
The VGA cable is not provided with the TE30. You need to purchase it by yourself.
The cable connection shown in the preceding figure is the simplest and provided only for reference.
http://enterprise.huawei.com
Collaboration > Telepresence and Videoconferencing > Videoconferencing Endpoints to access the
HUAWEI TE30 Videoconferencing Endpoint User Guide for more cable connection instructions.


Powering On the TE30

With all cables connected correctly, use the power adapter to connect the TE30 to a power supply.
1
When the power adapter indicator turns on, the TE30 automatically powers on and the Wizard
screen is displayed.
If the HDMI port is used for video output, after you set the parameters on the Wizard screen, the
2
menu screen is displayed.
If the VGA OUT port is used for video output, perform the following steps to access the menu
3
screen. Press and hold
Settings > Video > Common Settings, select Video Output, and select VGA OUT for GUI,
Caption output, and Main output interface.
The following table describes the TE30 indicator status.
4
Indicator TE30 Status
Status
Blinking Starting or
green upgrading
Steady Operating
green properly
Blinking Sleeping
orange


Loading the Configuration File

The TE30 automatically loads the configuration file on a USB device, such as a USB flash drive.
After the configuration file is loaded, the TE30 works properly. If no USB device is available,
load the configuration file on the Wizard screen.
8
and choose SUPPORT > Product Support > Unified Communications and
on the remote control for 5 seconds. Choose Advanced Settings >
Indicator
Status
Steady orange
Off
Blinking red
Do not turn the TE30 or stop it from turning using your hands or other
forces when the TE30 is powered on and working properly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
HUAWEI TE30 Videoconferencing Endpoint
TE30 Status
Powered off but connected to the power
supply
Disconnected from the power supply
Encountered a fault, such as a self-
check error, overheating, and software
malfunction
Visit
Issue 09 (2014-01-21)