Table of Contents
Advertisement
Available languages
Available languages
5.15 TROUBLESHOOTING
1
If the vehicle does not operate correctly, run the checks
and carry out the operations described herein.
2
If the problem persists, contact an Authorised
MALAGUTI Service Centre, which has the required
3
equipment and experience for any kind of
adjustment and repair.
4
FAULTY BRAKING SYSTEM
5
The vehicle does not brake or the brake lever travel is
too long.
6
•
For both hydraulic brakes, check the oil level in the
brake pump chambers, located on the handlebar,
and if necessary, have them topped up or purged
by an Authorised MALAGUTI Service Centre.
•
Check
the
every 1,250 mi (2,000 km).
ENG
46
thickness
of
the
brakes
THE ENGINE DOES NOT START
1) Brake lever not pulled:
• operate one of the two brake levers.
2) Main switch not activated:
• insert the key and turn it clockwise.
3) Flooded engine:
• contact
Centre.
• contact
Centre.
5) The starter motor runs too slowly:
the battery.
• If the fault remains, contact an Authorised
MALAGUTI Service Centre.
pads
6) The starter motor works but the vehicle does not start:
• Check the state of the spark plug; if necessary
clean or replace it.
• If the fault remains, contact an Authorised
MALAGUTI Service Centre.
an
Authorised
MALAGUTI
an
Authorised
MALAGUTI
Service
Service
Recharge
- Quick Links:
- Cruscotto Digitale
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Phantom F12R and is the answer not in the manual?
Questions and answers
Come accendere gli abbaglianti sul f12r del 2007 non so come si fa anche consultando il libretto
To turn on the high beams on a 2007 Malaguti Phantom F12R, follow these steps:
1. Locate the Headlight Control Switch – It is usually on the left handlebar.
2. Turn on the Ignition – Insert the key into the ignition and turn it to the "ON" position.
3. Activate the Low Beams – If the headlights are not already on, switch them to low beam mode.
4. Switch to High Beams – Use the high beam control, typically a switch or button on the left handlebar, to activate the high beams.
If the high beams do not turn on, check the bulb, fuse, or wiring for issues.
This answer is automatically generated
@Mr. Anderson grazie ma il mio f12r a gli auto anabbaglianti, praticamente appena accendo l'F12R si accende da solo lanabbagliante e non ci sono pulsanti per l'abbagliante e strano come cosa fatemi sapere ulteriori dettagli grazie e scusate la mia ignoranza