Entering Setup Data; Selecting Probe Type - GE PM880 User Manual

E n t e r i n g S e t u p D a t a
For immediate operation, the PM880 requires only a moisture
probe and its corresponding calibration data. You should enter
data for each site where you plan to make a measurement. Once
entered, you can save it into a file that can be recalled at the
measurement site. Use the sections that follow to program your
meter.
The PM880 has additional menus that enable you to tailor
N o t e :
measurements as specifically as possible to your
particular application. For more information on menu
options refer to Chapter 4, Using Special Features.
S e l e c t i n g P r o b e T y p e
Use the steps below to select the probe type for the measurement
site. Refer to Figure 1-9 on page 1-19 for a menu map.
You may also enter a constant value for moisture,
N o t e :
temperature or pressure measurement (rather than a live
input). For more information refer to Entering Constants
and User Functions on page 4-10.
1. If the menu is not active, press
2. Use the arrow key to scroll to Program and press
3. Use the arrow key to scroll to Probe and press
screen appears similar to Figure 1-3 below.
G e t t i n g S t a r t e d
F i g u r e 1 - 3 : T h e P r o b e W i n d o w
.
[MENU]
F e b r u a r y 2 0 0 5
.
[ENTER]
. The
[ENTER]
1 - 7