Table of Contents
Advertisement
BIOS upgrade and recovery (PL11, PL3)
Power Mode light colour (PL201)
M o t h e r b o a r d F e a t u r e s & U p g r a d e s
These jumpers should not normally be changed except by a service
engineer or at the direction of a service engineer.
CMOS is cleared by moving the PL11 jumper to the 2-3 position
for a few moments while the system is turned off, then returning it
to the normal 1-2 position.
You must ensure that BIOS reprogramming is enabled if you want
to use Electronic Fingerprinting or the optional Apricot LS Security
Card (LOC Technology).
Clearing CMOS
CMOS battery connected (default)
CMOS battery disconnected
BIOS reprogramming
Enabled (default)
Disabled
Normally, the Power Mode light is [red] when the system is in Off
mode. If you move the jumper on block PL201 to pins 2-3 (
the light is extinguished in Off mode.
PL11
1-2
2-3
PL3
1-2 (
PROG
2-3 (
)
DIS
OWNERS HANDBOOK
)
)
OFF
5/5
Advertisement
Table of Contents
