Table of Contents
Advertisement
E x p a n s i o n C a r d s
4/6
OWNER'S HANDBOOK
feature cable into the motherboard before you install the card;
otherwise, the card may get in the way of the connector. See
the Motherboard Features & Upgrades chapter to locate the
VESA/AMC connector.
CAUTION
Be careful how you use this connector. Some pins carry +5 V power
which could damage the expansion card if it is incorrectly attached.
7.
Position the expansion card alongside the slot in which you
wish to install it. Align the rear of the card with the slot in the
rear of the system unit, and, if the card is full length, align the
front of the card with the card guide.
8.
Slide the card into the slot ensuring that the card edge
connector engages correctly with the socket on the riser board.
Do not use excessive force.
9.
Secure the card by replacing the screw that you removed in
Step 4.
10. Connect any necessary signal cables to the card.
11. Ensure no other cables or connectors have become dislodged,
then replace the side and top panels.
Advertisement
Table of Contents
