Scsi Connections - HP M2402 User Manual

SCSI Connections

The router supports Fast/Ultra-2 Narrow/Wide SCSI. The router is factory
configured to support LVD/Single-Ended or HVD (Diff), or a mixture of both
types of SCSI buses. Up to twelve SCSI buses can be attached, using 3 SCSI
modules.
Note:
The router supplies termination power (TERMPWR) to each SCSI bus.
Note:
restarted once the fault is cleared.
Note:
cables are available from your supplier.
To connect the router to a SCSI device:
1. Power off the router and SCSI devices.
2. Locate the SCSI buses on the back-side of the router.
Network Storage Router M2402 User Guide
The router must always be installed at the end of SCSI buses.
During certain faults, the termination power IC will shut down. It may be
Caution: During the attachment of high density SCSI cables, note the
orientation of the high-density SCSI port connectors. Connector orientation
failure may result in connector damage.
Caution: LVD/SE and HVD connections must be made on appropriate I/O
modules. Failure to heed this caution may result in damage to equipment.
Caution: Failure to comply with the minimum high-density cable specifications
can result in damage to the router or an operational failure of the product.
SCSI cables used with the router must meet SCSI 2 standards. Optional SCSI
Installation
27