Verifying Scsi Devices In Windows Nt; Verifying The Router Configuration - HP M2402 User Manual

Verifying SCSI Devices in Windows NT

If running Fibre Channel-to-SCSI mapping mode, verify the Fibre Channel and
the SCSI devices are recognized by the router.
Sometimes Windows NT may need to be rebooted with all SCSI devices and the
router powered up before recognizing the devices.
Verify the Fibre Channel and the SCSI devices:

Verifying the Router Configuration

If you are in doubt about the configuration or about the location of the error,
restore the router to the factory default configuration and proceed to configure the
unit one step at a time, verifying the functionality of the configuration after each
change is made.
Network Storage Router M2402 User Guide
To verify the Fibre Channel devices, navigate to the Windows NT Control
Panel, select SCSI Adapters, and double click the Fibre Channel HBA.
The SCSI devices should be listed.
If no devices are listed, verify the router configuration, Fibre Channel HBA
configuration, and cabling.
If devices are listed, verify the Fibre Channel HBA mapping mode or the
AL_PA addresses.
To verify the SCSI devices, navigate to the Windows NT Control Panel, select
SCSI adapters, and double click the SCSI controller.
If no devices are listed, verify the router configuration, SCSI Controller
configuration, and cabling.
Caution: Restoring factory defaults overwrites user configurations. In the
serial/ Telnet interface, use the save configuration option before resetting
factory defaults, to allow recovery of user configuration.
Basic Troubleshooting
199