Sanyo MLS-3751 Instruction Manual page 3

Ground the product without fail.
Make sure that the product has been properly
grounded. Be sure to connect one end of
grounding line to the ground and the other end to
the grounding terminal.
Failure to observe this warning may result in electric
shock.
In the event of trouble, stop operation
and turn OFF the power.
Should trouble (burning smell, etc.) occur, set the
power switch to the OFF position, shut down the
main power, and contact the dealer from whom you
purchased the product.
Continuing to operate the product in anything but proper
working order may result in electric shock or fire.
Check the product for sterilization
performance.
The sterilization performance will vary depending
on such factors as the type and volume of objects
to be sterilized, the arrangement of objects and
the type of container. Therefore, use a sterilization
indicator such as an
performance.
Failure to observe this warning may result in accident
or incomplete sterilization.
WARNING
Ground
without fail!
Set my power
switch to OFF.
OK card
OK card for checking the
Do not extend the power cord.
Do not connect the power cord or plug to an
extension cord.
Failure to observe this warning may result in electric
shock or fire.
Do not modify the product.
The product should never be disassembled or
repaired by any other person than a qualified
service engineer.
Failure to observe this warning may result in fire,
malfunction or injury.
Do not open the drain valve during
operation.
Before draining off heating water, open the cover
for at least 2 hours after the end of operation.
Failure to observe this warning may cause hot water
to gush out, resulting in scald or accident.
(
Heating water is water that is poured into the
chamber to help the heater in the chamber
generate steam for sterilization.
Do not open
valve.
)
2