How To Use - Panasonic ES-LV9N Operating Instructions Manual

Preparing the cleaning liquid
Cleaning can start right after the usage by preparing in advance.
(See page 17.)
• Remove the AC adaptor from the self‑cleaning recharger.
1
Press the cleaning
liquid unit removal
button (1) and
remove the cleaning
liquid unit (2) on a
hard, flat surface.
• When the self‑cleaning recharger is lifted, or on the soft
surface such as carpets, the lock release lever will not fit
in the recharger properly. In that case, the cleaning liquid
unit cannot be removed.
2
Pour tap water (1) and
detergent (2) into the
cleaning liquid unit.
• Be careful not to let the
water rise above the
maximum water line (a).
• Pour the entire packet of
detergent.
3
Slowly insert the
cleaning liquid unit
[B] into the self-
cleaning recharger [B]
until it clicks.
14
ES-LV9N_EU.indb 14


 

Notes
• To replace the cleaning liquid, see page 20.
• Only use self‑cleaning recharger detergent for Panasonic
shavers.
Not doing so may cause malfunction or failure.
• Do not tilt the self‑cleaning recharger.
Doing so may cause spill or the number of days that cleaning
liquid can be used reduce.
• You can use the cleaning liquid for approximately 30 days if
used once per day.
(This will differ depending on beard thickness and the
ambient temperature.)

How to use

Shaving beard
1
Press and shave.
• The "shaving sensor", which automatically
adjusts the power depending on the beard
thickness, will operate.
It will shave with high power on areas
where the beard is heavy, and reduce the
power on areas where the beard is thin, to
reduce burden on the skin.
• The power cannot be turned on when the switch lock
lamp ( ) blinks, as the power switch is locked.
Press the power switch for more than 2 seconds to
unlock.
(See page 16.)
2015/12/11 13:05:52