Start-Up; Contents Of This Chapter; Start-Up Procedure - ABB ACS580-04 Hardware Manual

Start-up

Contents of this chapter

This chapter describes the start-up procedure of the drive.

Start-up procedure

1. Only qualified electricians are allowed to start-up the drive.
2. Make sure that the installation of the drive module has been checked according to the
checklist in chapter
ready for start.
3. Perform the start-up tasks instructed by the cabinet-installer of the drive module.
4. Switch the power on, setup the drive control program, and perform the first start of the
drive and motor. See the ACS580-04 quick installation and start-up guide
(3AXD50000015469 [English]) or ACS580 firmware manual (3AXD50000016097
[English]). If you need more information on the use of the control panel, see ACS-AP-x
Assistant control panels user's manual (3AUA0000085685 [English]).
For drive modules in which the Safe torque off function is in use: Test and validate the
operation of the Safe torque off function. See section
page 142.
Installation checklist, and that the motor and driven equipment are
9
Start-up including acceptance test
Start-up 99
on