Configuration And Loading Files; Configuring Network Parameters Using Buttons - Huawei eSpace 6805 Administrator's Manual

Huawei IP Phone eSpace
6805&6810&6830&6850&6870
Administrator Guide
If the number of IP phones is small or the environment for centralized upgrade is not provided
on site, configure and upgrade IP phones one by one.
This chapter uses eSpace 6870 to illustrate the procedures for configuring an IP phone. The
procedures for configuring eSpace 6805, eSpace 6810,eSpace 6830, eSpace 6850, and eSpace
6870 are similar. The procedure for setting the network parameters such as the IP address for
eSpace 6870 through the button is typical. The differences between eSpace 6805, eSpace
6810,eSpace 6830, eSpace 6850 and eSpace 6870 are described independently.

2.1 Configuring Network Parameters Using Buttons

If the DHCP server exists on site, an eSpace 6870 IP phone can obtain an IP address through
DHCP. By default, eSpace-series IP phones obtain IP addresses through DHCP. If the eSpace
6870 IP phone obtains an IP address successfully, the IP address is displayed. You can use the
displayed IP address to log in to the Web page of the IP phone to set the other parameters.
If the DHCP server does not exist on site, you must set the network parameters for the eSpace
6870 IP phone separately. The procedures for setting the IP address, SIP server, and SIP
account through the keypad for eSpace 6870 are complicated. Therefore, it is recommended
that you set the IP address through the keypad, and log in to the Web page to set the other
parameters.
To set a static IP address through the keyboard in the English system, proceed as follows:
1.
2.
3.
4.
5.
6.
Issue 01 (2012-06-20)
2

Configuration and Loading Files

Press the MENU key on eSpace 6870 to enter the configuration page.
Press the Up or Down key to select Network, and press the MENU key.
Press the Up or Down key to select IP Setting, and press the MENU key.
Press the Up or Down key to select Static IP, and press the MENU key.
Press the Up or Down key to select IP, and press the MENU key. Press the BackSpace
key to delete an IP address, enter the required IP address, and press the OK key.
Repeat step 5 to set Netmask and Gateway.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Configuration and Loading Files
4