Table of Contents
Advertisement
Holding UP/DOWN keys longer will
change the frequency as long as the keys
are being pressed.
To skip monitoring unwanted signal and
continue scanning, rotate the dial or use
UP/DOWN key to move to another
frequency.
1.
Enter to the Memory mode of the desired
band.
2.
Operations are the same as VFO scan.
In case the scanning is not performing as you expect, check the Skip and
NOTE
Favorite setting below and memory scan mode selection in the set mode.
1.
Enter to the Dual-Memory mode.
2.
Pressing and holding either left or right
dial will start scanning, in accordance
with the scan mode assigned to the
operated side.
In case of UP/DOWN key operation, scan
mode will depend on the MAIN-side.
A memory channel set as skip-channels will be excluded from scanning during memory
scan.
In contrary, if you have frequently monitoring channels, set them as Favorite for faster
memory-scanning.
1.
In the memory mode, select a memory
channel to be skipped or set as a
Favorite.
2.
Press the FUNC key then press the V/M
key while the [FUNC] icon is displayed.
SKIP icon starts ashing.
Useful functions
59
Advertisement
Table of Contents
Need help?
Do you have a question about the DR-735T/E and is the answer not in the manual?
Questions and answers
How do I access the tone needed to access a repeater.?
To access the tone needed for a repeater on the Alinco DR-735T/E, follow these steps:
1. Ensure the transmitting band is set to the MAIN side.
2. Monitor the frequency to avoid disturbing ongoing communications.
3. Press the PTT key on the microphone to transmit.
4. If a tone burst is required, press the DOWN key together with the PTT key to transmit the Tone Burst signal.
5. If auto-dialer tones are needed, press the UP key with the PTT key.
Additionally, if tone squelch or DCS decoding is active, it must be turned off to monitor the repeater’s downlink.
This answer is automatically generated