Table of Contents
Advertisement
This is to select the channel step to be used in the VFO mode. Details are already explained
in P.21. The values are variable only in the VFO mode. Warning beep sounds when operated in
the memory mode.
This is to select the operating modulation mode. AM mode is not available for transmitting.
A narrow FM mode is becoming popular in amateur radio, and is also used in VoIP
communications.
The modulation level becomes half in narrow mode and receiving audio level increases. The
mode selection is stored independently for each band and memory channel.
This operation is possible in the memory mode but the change affects only temporary.
1.
Press and hold FUNC key to enter the set
mode. Press dial to select menu 02.
Factory default setting is [Auto].
2.
Rotate the dial to select FM, NFM, AM or
NAM. When NFM or NAM selected, Nar
will appear on the display.
3.
Repeat the same operation by selecting
another side of VFO if the same mode is
always desired when operating the same
band.
4.
Press any key to set and exit, or press the
dial or UP/DOWN keys to set and move to
another menu.
1.
Press and hold FUNC key to enter the set
mode. Press dial to select menu 03.
Factory default setting is [0dB]. This
value becomes effective regardless of the
band or VFO.
2.
Rotate the right dial to select a value
between -23dB and +23dB.
Selecting (-) will decrease and (+) will
increase microphone gain. The
microphone gain is adjustable while
transmitting.
36
AUTO
FM
NFM
AM
NAM
Advertisement
Table of Contents
Need help?
Do you have a question about the DR-735T/E and is the answer not in the manual?
Questions and answers
How do I access the tone needed to access a repeater.?
To access the tone needed for a repeater on the Alinco DR-735T/E, follow these steps:
1. Ensure the transmitting band is set to the MAIN side.
2. Monitor the frequency to avoid disturbing ongoing communications.
3. Press the PTT key on the microphone to transmit.
4. If a tone burst is required, press the DOWN key together with the PTT key to transmit the Tone Burst signal.
5. If auto-dialer tones are needed, press the UP key with the PTT key.
Additionally, if tone squelch or DCS decoding is active, it must be turned off to monitor the repeater’s downlink.
This answer is automatically generated