Table of Contents
Advertisement
Set mode menu
The DR-735T/E has an advanced set mode which is used for even more detailed customizations.
Available menus are mostly "set-and-forget" so this mode can be hidden.
Menu
Default Display
22
APO OFF
23
TOT OFF
24
TOTP OFF
25
TB 1750
26
BCL - OF BCL - OF
27
S - MUTE OFF
28
SCNLMP OFF
29
FAN AUTO
30
VM 0 UM 0
31
HTR - N HTR - N
32
TNC OFF
33
MEMORY COMMON
34
AFMUTE OFF
Press and hold H/L key until,
consecutive manner until beep is heard and a
in the set mode menu. After being completed the advanced setting, you may repeat the same operation to
hide the advanced menus. The saved values remain unchanged.
48
Function
Auto power off (APO)
Time out timer (TOT)
TOT penalty
Tone burst tones
Busy channel lock out (BCLO)
SUB band mute during transmission
Scan illumination
Cooling fan operation
Mid power output
Image signal rejection
TNC output
Memory channel mode selection
Mutes SUB band RX while receiving in MAIN
appears on the display. Within 10 seconds, press H/L key 5 times in a
icon appears on the display. The Menu 22 ~ 34 are added
Default
Value
OFF
OFF
OFF
1750
OFF OFF
OFF
OFF
AUTO
0 0
N N
OFF
COMMON
OFF
Advertisement
Table of Contents
Need help?
Do you have a question about the DR-735T/E and is the answer not in the manual?
Questions and answers
How do I access the tone needed to access a repeater.?
To access the tone needed for a repeater on the Alinco DR-735T/E, follow these steps:
1. Ensure the transmitting band is set to the MAIN side.
2. Monitor the frequency to avoid disturbing ongoing communications.
3. Press the PTT key on the microphone to transmit.
4. If a tone burst is required, press the DOWN key together with the PTT key to transmit the Tone Burst signal.
5. If auto-dialer tones are needed, press the UP key with the PTT key.
Additionally, if tone squelch or DCS decoding is active, it must be turned off to monitor the repeater’s downlink.
This answer is automatically generated