Removing Sweeper From The Prime Mover - Toro 07050 Operator's Manual

3
1. Sweeper jack
2. Hitch tongue (Model
07050)
4. Back the prime mover up to the sweeper.
5. Adjust the sweeper hitch tongue to the same level as
the hitch of the prime mover as follows:
• Remove the bolts and locknuts securing the hitch
tongue to the frame.
• Raise or lower the hitch tongue to the position
approximately level with the prime move hitch
and secure it with the 2 bolts and locknuts.
3
Removing Sweeper from the
Prime Mover
No Parts Required
Procedure
WARNING
Always empty the sweeper hopper before
disconnecting the hopper from the prime mover or
the sweeper may tip backwards and cause injury.
1. Park the sweeper on a level surface and block the
wheels.
2. Insert the castor wheel onto the jack tube.
1
23 1/2
2
g01525 6
Figure 3
3. Adjusting screws
3. Raise the sweeper jack handle and lower the caster
wheel to ground.
4. Continue to raise the sweeper with a jack until the
hair pin cotter and hitch pin can be removed from
the hitch.
10