Toro 30410 Operator's Manual page 3

Activating, Charging, and
Connecting the
Battery .............................. 41
Battery Care ...................................... 43
Fuses................................................. 43
Drive System Maintenance......................... 43
Changing the Planetary Gear Drive
Oil..................................... 43
Changing the Rear Axle
Lubricant .......................... 44
Checking the Rear Wheel
Toe-In ............................... 44
Cooling System Maintenance ..................... 45
Servicing the Engine Cooling
System............................... 45
Brake Maintenance .................................... 45
Adjusting the Service Brakes .............. 45
Belt Maintenance....................................... 45
Servicing the Alternator Belt .............. 45
Re-tensioning the Blade Drive
Belts.................................. 46
Replacing the Blade Drive Belt ........... 46
Controls System Maintenance.................... 47
Adjusting the Throttle ....................... 47
Adjusting the Traction Pedal
Linkage ............................. 47
Hydraulic System Maintenance .................. 48
Changing the Hydraulic Fluid............. 48
Replacing the Hydraulic
Filters................................ 48
Checking the Hydraulic Lines and
Hoses................................ 49
Hydraulic System Test Ports............... 49
Adjusting the Cutting Unit Flow
Control ............................. 51
Mower Maintenance .................................. 51
Adjusting the Transport Latch............ 51
Pivoting (Tilting) the Front Cutting
Unit Upright...................... 52
Pivoting the Front Cutting Unit
Down................................ 52
Adjusting the Cutting Unit
Pitch.................................. 53
Servicing the Castor Arm
Bushings ........................... 54
Servicing the Castor Wheels and
Bearings ............................ 54
Blade Maintenance .................................... 55
Checking for a Bent Blade .................. 55
Removing and Installing the Cutter
Blade(s) ............................. 55
Inspecting and Sharpening the
Cutter Blade(s) .................. 56
Correcting Cutting Unit
Mismatch .......................... 57
Spark Arrestor Maintenance ...................... 57
Servicing the Spark Arrestor
Muffler.............................. 57
Storage .............................................................. 59
Preparing for Seasonal
Storage .............................. 59
Schematics ........................................................ 60
3