Specifications; Operation; Before Operating - Toro 30410 Operator's Manual

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Before Operating

If you leave the key in the ignition switch,
someone could accidently start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition before you
do any maintenance.
Checking the Engine Oil
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and
after the engine is first started.
The crankcase capacity is 8 qt (7.6 l) with the filter.
Use high-quality engine oil that meets the following
specifications:
• API Classification Level Required: CH-4, CI-4
or higher.
• Preferred oil: SAE 15W-40 (above 0°F)
• Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Toro Premium Engine Oil is available from your
distributor in either 15W-40 or 10W-30 viscosity.
See the parts catalog for part numbers.
1. Park the machine on a level surface. Unlock
the engine cover latches.
2. Open the engine cover.
3. Remove the dipstick, wipe it clean, install the
dipstick into the tube, and pull it out again.
The oil level should be up to the Full mark
(Figure 5).
1. Dipstick
4. If the oil is below the Full mark, remove the
fill cap (Figure 6) and add oil until the level
reaches the Full mark. Do not overfill.
1. Oil ll cap
5. Install the oil fill cap and dipstick.
6. Close the engine cover and secure it with the
latches.
Checking the Cooling System
Check level of coolant at the beginning of each day.
Capacity of system is 2-3/4 U.S. gallons (10.4 l).
1. Carefully remove the radiator cap and
expansion tank cap (Figure 7).
19
Figure 5
Figure 6