Toro 30410 Operator's Manual page 26

Figure 22
1. Damper link
Figure 23
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than
2-1/2 inches (64 mm) and in the higher position
when operating in height of cuts lower than 2-1/2
inches (64 mm).
Adjust the skids by removing the flange bolt and
nuts, positioning them as desired, and installing
the fasteners (Figure 24).
Figure 24
1. Skid
Adjusting the Cutting Unit Rollers
The cutting unit rollers should be mounted in
the lower position when operating in height of
cuts greater than 2-1/2 inches (64 mm) and in the
higher position when operating in height of cuts
lower than 2-1/2 inches (64 mm).
1. Remove the bolt and nut securing the gage
wheel to the cutting unit brackets (Figure 25).
Figure 25
1. Gage wheel
2. Align the roller and spacer with the top holes
in the brackets and secure them with the bolt
and nut.
Correcting Mismatch Between Cutting
Units
Due to differences in grass conditions and the
counterbalance setting of the traction unit, it is
advised that grass be cut and appearance checked
before formal cutting is started.
1. Set all cutting units to the desired height of cut;
refer to Adjusting the Height of Cut table in
Specifications, page 18.
26