Toro 30410 Operator's Manual page 22

Figure 10
1. Check/drain plug
2. Remove the plug on the planetary (Figure 10)
and check the plug on the back side of the
brake (Figure 11). Oil should be at the bottom
of the check plug hole on the back side of the
brake.
Figure 11
1. Brake housing
3. Add gear oil to the hole in the planetary, if
necessary, to bring the oil up to the proper
level. Install the plug.
4. Repeat steps 1-3 on the opposite gear assembly.
Checking the Rear Axle Lubricant
The rear axle is shipped from the factory filled
with SAE 85W-140 gear lube. Check the oil level
2. Check plug
before the engine is first started and every 400
hours thereafter. The capacity is 80 oz (2.4 l).
Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from one end of the axle
(Figure 12) and make sure that the lubricant
is up to the bottom of the hole. If the level is
low, remove the fill plug (Figure 12) and add
enough lubricant to bring the level up to the
bottom of the check plug holes.
Figure 12
1. Check plug
Checking the Rear Axle Gear Box
Lubricant
The gear box is shipped from the factory filled
with SAE 85W-140 gear lube. Check the oil level
before the engine is first started and every 400
hours thereafter. The capacity is 16 oz (0.5 l).
Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side
of the gear box (Figure 13) and make sure that
lubricant is up to the bottom of the hole. If the
level is low, add enough lubricant to bring the
level up to the bottom of the hole.
22
2. Fill plug