(Except For The Bypass Tray); Specifying The Size When The Paper Size Is Set To "Extra" (Except For The Bypass Tray) - Sharp AR-C260P Operation Manual

Specifying the size when the paper size is set to "Extra"

(except for the bypass tray)

When the size slide on a paper tray is set to "extra", follow the steps below to specify the paper size.
For example, if 8-1/2" x 11" size paper is loaded in the tray (with the size slide set to "extra"), use this procedure to
set the "extra" paper size to 8-1/2" x 11" size. If you loaded an non-standard size of paper, you can enter the
dimensions of the paper.
To set the paper size when an extra size of paper is loaded in the bypass tray, see page 2-15.
Perform steps 1 through 8 of "Setting the
1
paper type (except for the bypass tray)" on
the previous page.
Press the [OK] key.
2
EXTRA
OK?
(The currently set paper size of the selected paper
tray will appear.)
Press the key or
3
appropriate paper size appears. If a
non-standard size of paper is loaded,
press the key or
OK?" appears.
Example 1
To select 8-1/2" x 11" size on an AB-based model,
press the or key until the following display
appears.
LETTER
OK?
Example 2
To select a special size, press the
until the following display appears.
EXTRA
OK?
4 Press the [OK] key.
GIf you selected a size other than "EXTRA
OK?" in step 3 (such as "LETTER OK?" in the
above example), go to step 7.
GIf you selected "EXTRA OK?" in step 3, go to
step 5.
5 Press (or hold down) the
the X dimension and press the [OK] key.
PAPER SIZE SETTING
X:139mm
the number is the currently set dimension (for
example, 139 ).
The permitted range for the X dimension is 139 to
432 mm (5-1/2 to 17 inches).
The display at left
appears in the factory
default state.
key until the
key until "EXTRA
or key
or key to set
An asterisk " "
appearing next to a
number indicates that
Press (or hold down) the
6
the Y dimension.
PAPER SIZE SETTING
Y:100mm
the number is the currently set dimension (for
example, 100 ).
The permitted range for the Y dimension is 100 to
297 mm (4 to 11-3/4 inches).
Press the [OK] key.
7
8 Press the [MENU] key to complete the
setting.
LOADING PAPER
or key to set
An asterisk " "
appearing next to a
number indicates that
2-13
2