Opening The Access Covers - Toro 22303 Operator's Manual

POTENTIAL HAZARD
If you leave the key in the ignition switch, someone could start the engine.
WHAT CAN HAPPEN
Accidental starting of the engine could seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Remove the key from the ignition switch and and disconnect negative battery cable
from battery before you do any maintenance.

Opening the Access Covers

Removing the Front Access Cover
1. Raise the loader arms and install the cylinder
locks; refer to Using the Cylinder Locks,
page 22.
Note: In the case that you need to remove the
front access cover without raising the
loader arms, be very careful not to
damage the cover or hydraulic hoses as
you maneuver the cover out from
under the arms.
2. Stop the engine and remove the key.
3. Release the two locking tabs (Fig. 20).
4. Pull the cover off of the traction unit (Fig. 20).
1
2
Figure 20
1. Front access cover
5. When finished, replace the front access cover
and secure it with the two locking tabs.
Opening the Rear Access Cover
1. Stop the engine and remove the key.
2. Release the two locking tabs on top of the rear
access cover (Fig. 21).
3. Grasping the handle, pull the cover up and back
to swing it open (Fig. 21).
Maintenance
m–4595
2. Locking tabs
27